====== BSD ======

{{:ai:pasted:20201011-064420.png}}

==== BSD Installation ====
  - BSD camera should mount on the side of the vehicle that opposite and lens face forward to the vehicle, 195 ± 15cm high from the ground. (See the red area in the image below)
  - Check the live view image from the camera calibration and run an alarm test BEFORE securing as it requires a clear and specific image.

{{:ai:pasted:20201011-062423.png}}

==== BSD Calibration ====
  - Place a cone in front of the BSD camera that 2 meters far from the headstock.
  - Open Liveview page, Click the "AI Calibration" button to enter the next page.
  - Select "BSD" to enter the next page.
  - Select "Left BSD" or "Right BSD" to enter the next page.
  - Select the actual channel to which you connected the BSD camera to calibrate.
  - Click the Left & Right arrow button to move the red vertical line. Make the vertical line coincide with the body edge.
  - Click the Up & Down arrow button to move the yellow horizontal line. Make the horizontal line coincide with the cone.

{{:ai:pasted:20201011-063521.png}}

{{:ai:pasted:20201011-062502.png}}

==== BSD Detection Area ====
The figure below shows a virtual detection area for the BSD system. the area highlight in yellow are the blind sports of the BSD camera itself (4~5 m). The Red area shows the “alarm area” where close to the vehicle, the Green area is the pre-alarm area that system indicate the potential collision.

{{:ai:pasted:20201011-062539.png}}